Before Jimmy starts shipping this kit, he needed to know if everything fit. With this in mind, here is what I did.
I removed the wall sections from each bag and measured the walls. I started with the large center building first. The walls measured 4 27/32" in length or width as you will. These were correct! Note, my green ink is on the back side of each section.
The gabled or "A" frame end meausred 3 13/16" side. These were correct. The wall heights were all even with each other.
I next took the doors and windows and fit them into the window and door openings. This is where I found some size/opening issues. So, Jimmy here is where the changes need to be made. Again, staying with the large center building here is what I found. On the two side walls, the opening for the freight doors is 1/32 short. The door opening needs to be cut a 1/32 inch higher on the freight door opening. This applies to each freight door on each wall section of the center building. You can see the freight door larger than the opening in this photo.
Also, on the side wall with the tall single door and the three windows above the door, the door opening on this section is is 1/32" shorter than the door. You can see the full wall section in jdb8.jpg above. The next photo shows this door 1/32 hanging out. This door opening needs to be cut 1/32" higher.